Cycle Analyst 4.0k26PV - Settings Summary
RELEASE NOTES    CAV3 ONLINE


1.0 Overview

This is an overview of the Settings available via the Software Setup Utility or directly on the Cycle Analyst Console. Each interface displays settings in a slightly different order and each provides access to a few settings not available by the other. Certain settings can become irrelevant because of other configured settings. The CA hides many such irrelevant settings on the Console although they still show up in the Setup Utility.

2.0 Category Index


- Test Parameters


IMPORTANT: The Cycle Analyst normally has direct control of the motor controller making unexpected motor operation possible while installing firmware or modifying settings. For safety, the bike should be placed on a stand or the motor disabled while such operations are underway.

3.0 SETTING DESCRIPTIONS

A setting title ending with an asterisk (*) indicates that the setting can be uniquely customized for each preset or battery. Settings without an asterisk are global and apply to all presets.


3.1 Test Parameters

Parameters to set up test screens or general device configuration.

    [ TEST->PAS Volts ]
    Select either 5V or 11V to be supplied at the PAS connector by the CA. Selecting 11V for 5V devices may permanently damage the PAS unit.

    [ TEST->Zero Angle Offset]
    The positive or negative offset in degrees of the zero (level) angle reading. This value allows the console to be mounted with an upward or downward tilt and still properly read the overall vehicle angle.

    [ TEST->Zero Tilt Offset ]
    The positive or negative offset in degrees of the zero (level) tilt reading. This value allows the console to be mounted with a left or right tilt and still properly read the overall vehicle tilt.



  2020-01-03 [top]