This is a new Stokemonkey Motor from Crysalyte based on their SAW motor series, and it uses the same axle design with internal M6 bolt threads as the original 400 series Stokemonkey motors. If doing a custom bracket, it is essential to make it from steel between 5-6mm thick, and to provide a tight fitting and deep 10mm axle slot. The wire side of the axle has a groove that results in minimal contact surface with the inside of the bracket, and so most of the spinout retention comes from the freewheel side axle only.
For more information please see the Stokemonkey page
|Actual Weight (kg)||5.0400|
|Country of Manufacture||China|
|Motor Type||Direct Drive|
|Motor Power Range (Watts)||500-1000|
|Motor KV (RPM / V)||8.6|
|Phase Resistance (Ohm)||0.31|
|Axle Length (O.L.D.)||120|
|Magnetic Pole Pairs||20|
|Hysteresis Losses (N-m)||0.49|
|Eddie Losses (N-m / rad/sec)||0.01|
5 pin JST-SM series connector for the hall sensor
Genuine Anderson Powerpole connectors for the phase wires.